Only by applying a perfect polish, jewelery gets their appealing appearance. On one side the abrasiveness should be as low as possible to avoid material loss and on the other side high luster without any microcracks is targeted. The abrasive material plays an important role to achieve these targets.
Special polishing alumina with top cut of 45μm and high oil absorption for finishing of soft metals, plastics and paints.
Special polishing alumina with a very tight controlled top cut of <20μm for high end finishing applications.
Alumina with top cut of 45 μm / 325 mesh, which can be used on all kinds of surfaces.
Alumina with top cut of 40 μm?and best cost-performance ratio for the finishing of all kinds of surfaces.
Alumina with top cut of 20 μm giving nearly scratch free surfaces.
Very soft and fine alumina, which is mainly used for cleaning purpose after the finishing step.